Weaving-fabric manufacture

The weaving process uses a loom. The lengthway threads are known as the warp, and the cross way threads are known as the weft. The warp, which must be strong, needs to be presented to loom on a warp beam. The weft passes across the loom in a shuttle, that carries the yarn on a pirn. These pirns are automatically changed by the loom. Thus, the yarn needs to be wrapped onto a beam, and onto pirns before weaving can commence.

After being spun and plied, the cotton thread is taken to a warping room where the Fabric winding machine ( WITH DIRECT CENTRE DRIVEN SYSTEM )takes the required length of yarn and winds it onto warpers bobbins
Warping or beaming textile

Racks of bobbins are set up to hold the thread while it is rolled onto the warp bar of a loom. Because the thread is fine, often three of these would be combined to get the desired thread count.
Slasher sizing machine needed for strengthening the warp by adding starch to reduce breakage of the yarns.
Drawing in, Looming
The process of drawing each end of the warp separately through the dents of the reed and the eyes of the healds, in the order indicated by the draft.
Pirning (Processing the weft)
Pirn winding frame was used to transfer the weft from cheeses of yarn onto the pirns that would fit into the shuttle
Main article: Power loom
At this point, the thread is woven. Depending on the era, one person could manage anywhere from 3 to 100 machines. In the mid nineteenth century, four was the standard number. A skilled weaver in 1925 would run 6 Lancashire Looms. As time progressed new mechanisms were added that stopped the loom any time something went wrong. The mechanisms checked for such things as a broken warp thread, broken weft thread, the shuttle going straight across, and if the shuttle was empty. Forty of these Northrop Looms or automatic looms could be operated by one skilled worker.

A Draper loom in textile museum, Lowell, Massachusetts
The three primary movements of a loom are shedding, picking, and beating-up.
Shedding: The operation of dividing the warp into two lines, so that the shuttle can pass between these lines. There are two general kinds of sheds-“open” and “closed.” Open Shed-The warp threads are moved when the pattern requires it-from one line to the other. Closed Shed-The warp threads are all placed level in one line after each pick.
Picking:The operation of projecting the shuttle from side to side of the loom through the division in the warp threads. This is done by the overpick or underpick motions. The overpick is suitable for quick-running looms, whereas the underpick is best for heavy or slow looms.
Beating-up: The third primary movement of the loom when making cloth, and is the action of the reed as it drives each pick of weft to the fell of the cloth.
The Lancashire Loom was the first semi-automatic loom. Jacquard looms and Dobby looms are looms that have sophisticated methods of shedding. They may be separate looms, or mechanisms added to a plain loom. A Northrop Loom was fully automatic and was mass produced between 1909 and the mid-1960s. Modern looms run faster and do not use a shuttle: there are air jet looms, water jet looms and rapier looms.