Textile folding machine installation method

1. When the folding machine is transported by the manufacturer to your laundry room, you must first check the dryer regularly to check whether it is the machine you purchased and whether it is damaged or unusable during the transportation process. If there is a problem, take photos immediately and contact the manufacturer.
2. Before the folding machine, you should determine the installation position of the dryer. The installation position of the folding machine should consider the location of the transportation channel, raw material turnover, water inlet, steam inlet and sewer pipe. Here, the Xingxing washing equipment reminds you that the folding machine should be installed. Together with equipment such as dehydrators and dryers, the distance between these devices is reduced to prevent subsequent troubles due to improper selection of locations.
3. The textile folding machine belongs to one of the larger and heavier laundry equipments, so the machine should be installed on a solid foundation and kept at the same level to prevent the equipment from working due to the uneven location of the site and the installation location. Large vibrations occur, which affects the washing efficiency and the service life of the dryer.
4. Refer to the instruction manual of the folding machine, and find the electric control cabinet door of the folding machine according to the relevant contents in the manual. Connect the 380V three-phase power supply line and the neutral line according to the binding post. (There is to be reminded that the power of the folding machine must be 380V, no access to low voltage or high voltage)
5. Refer to the folding body label to indicate the corresponding access to the water inlet pipe and the steam pipe. If the steam condition is not available, the steam inlet port may be blocked. If steam heating is used, install pressure indicating devices and safety devices at the obvious location of the steam main pipe outside the machine.
Precautions´╝Ü
1. The installation of the folding machine is completed through the above five steps. At the time of installation, we should also pay attention to the following problems: the installation environment of the folding machine is best for dry, ventilated, clean working environment, good working environment and extended drying The key factor in the service life of the dryer.
2. When installing, you should strictly refer to the installation contents provided by the manufacturer to carry out the step-by-step operation. Do not install it according to your own feelings.
3. When there is a problem during installation, you should contact the manufacturer at the first time.

Source: Baidu Encyclopedia

Leave a Reply

Your email address will not be published. Required fields are marked *